52292509 运行监测器
建议项目
Only available if 4 or 5 ControlPro’s are connected to same CAN bus. Can be checked from ControlPro parameter: 4-11-1 Hoist cnt. Work number and position code (HOIST A/B/C/D1/D2) needed for order text line. Control Voltage: 48V
Only available if the original ControlPro uses RS232 serial link, e.g., for PC software (optional) or PLC system. Needs to be checked from electrical diagram. Work number and position code (HOIST A/B) needed for order text line. Control Voltage: 48V
Only available if the original ControlPro has POW Motor torque calculation measurement. Can be checked from ControlPro parameter: 4-7-1 is Motor. Work number and position code (HOIST A/B) needed for order text line. Control Voltage: 48V
Master Pro retrofit kit to replace ControlPro. Designed for single hoists, no POW measurement, no modem, no parameters. Supports all control voltages, comes with instructions.
Master Pro 改装套件，用于替代 ControlPro。 专为单起重葫芦而设计，无 POW 测量，无调制解调器，无参数。 支持所有控制电压，随附说明。
Master Pro retrofit kit to replace ControlPro. Designed for multi-hoisting, no POW measurement, no modem. NOTE: When one ControlPro in a multi-hoisting system is replaced by a Master Pro, ALL ControlPro must be replaced!
Master Pro 改装套件，用于替代 ControlPro。 专用于多起升，无 POW 测量，无调制解调器，无参数。 注意： 当多起升系统中的一个 ControlPro 更换为 Master Pro 时，必须更换所有 ControlPro！
Master Pro retrofit kit to replace ControlPro. Designed for multi-hoisting, no POW measurement, no modem, no parameters. NOTE: When one ControlPro in a multi-hoisting system is replaced by a Master Pro, ALL ControlPro must be replaced!
Master Pro retrofit kit to replace ControlPro. Designed for single hoists, no POW measurement, no modem. Supports all control voltages, comes with instructions.
The product availability for the current offering of condition monitoring units (CID) is limited. There are options to replace the current products with the CID – ECU upgrade kits.
Please replace with the CID - ECU upgrade kit:
- 69754566 UPGRADE KIT ECU-UPGR-STD-0-0-0-K (NOT Parameterized)
If there are 2-3 condition monitoring units (CID) in the same bus, you need to also order 1 piece or 2 pieces from the following:
- 69811842 UPGRADE KIT 2-3 ECU-STD-0-0-0-K (NOT Parameterized)
Please note, the CID - ECU upgrade kit is not suitable for the following applications because ECU doesn’t support:
- POW measurement
- Serial communication (RS232)
- Communication between CID and ECU
You can order the following products for these:
- 69760518 CID048_POW_PARAMETRIZED
Can be checked from CID parameter: 4-7-1 is Motor
- 69760520 CID048_PLC_ PARAMETRIZED (CPI and CXT smart)
Needs to be checked from electrical diagram
- 69760522 CID048_MULTI_ PARAMETRIZED, (if the crane has 4 to 5 CID’s)
Can be checked from CID parameter: 4-11-1 Hoist cnt
| 重量 | 0.55 kg |
| 海关编码: | 9032899099 |